Racing and Regattas

How Rowing Races Are Timed: Finish Lines and Photo Finishes

Race times run from the start to the moment a boat's bow crosses the finish line. Learn how judges, lane timers and photo-finish cameras decide results.

On this page
  1. Short answer
  2. Where the time starts and ends
  3. Judges at the finish
  4. Lane timers and backup timing
  5. Photo-finish systems
  6. The bow ball and close finishes
  7. Head race timing
  8. The 1877 dead heat

Short answer

A sprint race time runs from the start signal until the bow of the boat crosses the finish line. Judges at the finish decide the placings, and lane timers and photo-finish cameras help when the margin is small. In a head race, each crew’s time is its own elapsed time from its own start.

Where the time starts and ends

The official finish is the point when the bow of the boat crosses the finish line, not the stern or the crew. For the start, the time is taken from the start signal. Rules about the finish and the start are set out in the rules of rowing.

Judges at the finish

Judges stand at the finish line, often on a tower or platform, and decide the placing of each boat. They use timing equipment and, where available, a photo-finish camera. Their decision is the official result.

Lane timers and backup timing

Some regattas, especially school and club events, use a backup system. Each lane can have its own timer with a stopwatch. This gives officials a second set of times when the result is close. Some races can be decided by tenths of a second, so every timer matters.

Boats are usually signalled as they cross the finish line, with a horn, a flag or both, so the timers know when to stop.

Photo-finish systems

At major regattas, electronic photo-finish systems record the finish. A photo-finish camera captures many frames per second, which lets judges see which boat’s bow crossed first. One timing company describes its cameras as capable of recording up to 40,000 frames per second and accurate to 1/1000 of a second or better. These are the vendor’s own claims, and the official timing system at any given regatta will be set by its organisers.

The bow ball and close finishes

When a photo finish is needed, the bow of the boat is what counts. Some rowers refer to a “bow ball”, a small rubber tip on the bow of the boat, which can be used to indicate the winner in very close races. The term comes up in discussions of close finishes, so it is worth knowing when reading results.

Head race timing

In a head race, boats start at intervals, usually 10 to 15 seconds apart. Each crew’s time is measured from its own start to its finish, and penalty time is added if the crew breaks a rule. The crew with the shortest elapsed time wins. See Rowing races explained for the other race formats.

The 1877 dead heat

The Boat Race has recorded one dead heat, in 1877. The race was declared a dead heat, and the finishing line was not clearly marked by a post until the following year. That history shows how much a finish depends on clear markers and careful judging.

For how the finish fits into the time a race takes, see How long do rowing races take?. For the start that begins the clock, see How a rowing race starts.

The complete guide to racing and regattas

Rowing Races Explained: Race Types, Events and Names
Read the guide

Keep exploring

Guides from other topics

All topics →