Racing and Regattas

How a Rowing Race Starts: The Start Sequence Explained

Crews are aligned in their lanes, the starter calls the roll and gives the signal, and a second false start means disqualification. Here is the full sequence.

On this page
  1. Short answer
  2. Before the start: lanes and crews
  3. Step by step: alignment, roll call, commands
  4. Who does what at the start
  5. Stake boats and start gates
  6. False starts and restarts
  7. What the start means for the race

Short answer

Crews line up in their assigned lanes, are held and aligned by officials, and answer a roll call. The starter then gives a warning and the start signal. A crew is allowed one false start. A second false start means disqualification, and a restart is called if equipment breaks in the first 100 metres.

Before the start: lanes and crews

Each crew has an assigned lane, which is set by the regatta before the race. Lanes are marked by buoys and run the full 2,000 metres. You can read more about how lanes work in How rowing lanes work and why they matter.

Crews warm up, then move to the start and wait for the race to be called. The bow-seat rower is usually the one who signals that the crew is ready.

Step by step: alignment, roll call, commands

  1. Alignment. Each boat is held by its stern, and an official called the aligner makes sure the boats are even with each other and square to the course.
  2. Ready. The bow-seat rower raises a hand to show the crew is ready.
  3. Roll call. The starter calls the crews in turn, and each crew confirms it is ready.
  4. Warning. The starter gives a warning command, often “attention”, with a flag or signal.
  5. Start. The starter gives the start signal, which is audible and visual, such as a flag, a horn or a light.
  6. Race. The boats go, and the crews start with a high stroke rate.

Exact commands and signals vary between regattas, so follow the regatta’s notice.

Who does what at the start

  • Stake holders hold the stern of each boat in position until the start.
  • The aligner lines up the bows so that each boat is even with the others and facing the course.
  • The starter runs the roll call, gives the warning and gives the start signal.
  • The judge-referee follows the race in a launch, checking that every crew has a fair chance and that the race is run safely.

Stake boats and start gates

Many regattas use stake boats, which are anchored platforms. Holders hold the stern of each boat, and officials move the shells until their bows are aligned.

Some regattas use a hydraulic start gate instead. A gate holds the bows of the boats until the start command is given. The method varies by venue, so check how the regatta starts its races.

False starts and restarts

A false start is called when a crew leaves before the start signal. Each crew is allowed one false start. A second means disqualification.

If there is legitimate equipment breakage in the first 100 metres, such as an oar snapping, the race is stopped and restarted with repaired equipment. This rule protects crews from losing their race to a breakage at the start.

What the start means for the race

The start is the highest-rate part of the race, and it is the point where crews are most likely to make a mistake. Crews usually start at a high rate for an eight or a single, then settle to a rate they can hold through the middle. For how to plan that sequence, see How to build a rowing race plan. For the timing of the start and the finish, see How rowing races are timed.

The complete guide to racing and regattas

Rowing Races Explained: Race Types, Events and Names
Read the guide

Keep exploring

Guides from other topics

All topics →