Racing and Regattas

How to Build a Rowing Race Plan

Build a rowing race plan with phases for the start, middle and sprint, plus split targets, rate ranges and a plan for wind, water and the coxswain's calls.

On this page
  1. What a race plan does
  2. Know the race you are racing
  3. Phase 1: the start
  4. Phase 2: settle
  5. Phase 3: the middle
  6. Phase 4: the sprint
  7. Set your split and rate targets
  8. Wind, water and lanes
  9. Plan the calls
  10. Practise the plan
  11. Common mistakes

What a race plan does

A race plan decides how you will spend your effort over the race before the race starts. It sets the rate and split you aim for in each phase, so you are not guessing when the pressure rises. A plan is most useful when it is simple enough to remember and specific enough to check during the race.

Know the race you are racing

A standard senior sprint is 2,000 metres, which takes most crews somewhere in the region of 5.5 to 7 minutes. Eight-person crews often finish in around six minutes. The course has buoys every 500 metres, which give you natural checkpoints for your splits.

Masters and junior races are often shorter, so the phases will be shorter too. Adjust the plan to the distance on your entry.

Phase 1: the start

The start is the highest-rate part of the race. Crews usually start in the 40s strokes per minute for an eight and in the high 30s to low 40s for a single scull, according to USRowing and other sources. Sources differ on the exact numbers, so treat these as rough guides.

Plan a controlled, powerful start. A start that is too wild costs you the rhythm you need for the rest of the race, and it often leaves the crew with little for the middle.

Phase 2: settle

After the start, the crew should settle into a rate it can hold for most of the race. USRowing describes this as dropping into the high 30s for an eight and the low-to-mid 30s for a single. Settling is the point where the crew finds its rhythm and starts to look for speed rather than just effort.

Phase 3: the middle

The middle of the race is the longest phase, and it is where discipline matters most. Hold your rhythm, keep the crew together and check your splits at each 500-metre buoy.

Sports scientist Mark Homer, writing about the Boat Race, notes that the longer middle of that 6.8 km course encourages short hard pushes followed by recovery. A 2,000 metre race has a shorter middle, but the principle is similar: decide in advance where you will make your moves.

Phase 4: the sprint

The final push should be planned, not improvised. USRowing notes that finishing stroke rates of 46 or more in the last 200 metres are not unheard of. A higher rate does not guarantee more speed, though. A technically strong crew can cover more water at a lower rate than a weaker crew at a high rate.

Set your split and rate targets

A split is the time for each 500 metres. It is an easy way to see whether you are on pace. To turn a target time into splits, divide by four. For example, a 6:00 target for 2,000 metres means an average split of 1:30 per 500 metres.

Write down a split target for each 500 metres, plus a rate range for each phase. Use ranges, not single numbers, so you have room to adjust on the day.

Wind, water and lanes

Race times change with conditions. Tailwinds make times faster, while headwinds and crosswinds slow them down. Check the forecast, and look at the water in your lane before the race. If you have a choice of lane, think about how it is exposed to wind.

Plan the calls

In a boat with a coxswain, the cox calls the race and can use a “Power 10” to ask for ten hard strokes at a set point. Agree on the calls before the race, and make sure every rower knows what they mean. In a single, the plan is in your head, so the written card and your split targets matter even more.

Practise the plan

Practise race pieces at race pace, with the same split and rate targets you plan to use on the day. Pieces of a few hundred metres to a kilometre are common ways to do this. Training the plan, not just the effort, makes it easier to hold under pressure.

Common mistakes

  • Starting too hard and having nothing left for the middle.
  • Ignoring the wind and water, then blaming the crew for a slow time.
  • Chasing a high stroke rate instead of a steady, efficient one.
  • Forgetting the split targets, and only watching the clock on the bank.

For the mental side of holding a plan under pressure, see Mental toughness in rowing. For how a 2,000 metre time compares with an erg time, see What is a D1 2K rowing time?.

The complete guide to racing and regattas

Rowing Races Explained: Race Types, Events and Names
Read the guide

Keep exploring

Guides from other topics

All topics →