Training Zones

What does s/m mean in rowing?

In rowing, s/m means strokes per minute, also called stroke rate. Learn typical rates for each training zone and how to use the number on the erg or water.

On this page
  1. How stroke rate is counted
  2. Stroke rate in the training zones
  3. Rate is not power
  4. What rate do you use in races?
  5. Using rate on the erg
  6. Common mistakes

In rowing, s/m means strokes per minute. It is the number of strokes you take in one minute, with one stroke counted as a full cycle from catch to catch. You will also see it written as spm, or simply called stroke rate or “rate.”

How stroke rate is counted

One stroke is the full cycle: catch, drive, finish and recovery, ending back at the catch. On an erg, the monitor shows stroke rate, usually labelled as spm or stroke rate, depending on the model. On the water, coaches and coxswains often call the rate out, and some boats or watches display it.

Stroke rate in the training zones

Each training zone has a rough stroke-rate range. These are approximate, and they vary between coaches, athletes and boats:

  • UT2: about 18 to 22
  • UT1: about 20 to 24
  • AT: about 24 to 28
  • TR: about 28 to 32
  • AN: higher still, often 32 or more

Use the ranges as a starting point, and use the rowing training zones guide to see how they fit with pace and heart rate.

Rate is not power

A higher stroke rate does not automatically mean more power or a faster boat. Each stroke has to be efficient. Rowers who push the rate up without adding effective force often tire quickly and lose technique. A steady, relaxed rate with good force per stroke usually holds up better over a long piece.

What rate do you use in races?

Race starts are much higher than steady-state rates in training. Crews usually settle to a lower rate after the start, then push again in the finish. The right rate depends on the event, the crew and the conditions, so there is no single number to aim for.

Using rate on the erg

On the erg, rate helps you control effort. Holding UT2 at around 18 to 22 strokes per minute helps stop an easy session from drifting harder. Some workouts step the rate up in set blocks to train control and technique. How to build endurance in rowing covers how to keep easy pieces consistent, and UT2 training explains what easy rowing should feel like at those rates.

Common mistakes

  • Mixing up rate and split. Rate is strokes per minute. Split is the time per 500 m. A high rate with a slow split is a common sign of too little power per stroke.
  • Racing up the rate in steady work. A steady piece at a higher rate tends to become a harder piece.
  • Chasing a number. Rate is an output of good rowing, not the goal on its own. Focus on the feel and the power per stroke, and use rate to check that you are in the right zone.

The complete guide to training zones

Rowing Training Zones: UT2, UT1 and Beyond
Read the guide

Keep exploring

Guides from other topics

All topics →