Training Zones

Is Rowing Aerobic or Anaerobic? The Energy Systems Explained

Rowing uses both energy systems. See how aerobic and anaerobic work contribute in a steady row, a 2000 m race and a sprint, and why training both matters.

On this page
  1. The short answer
  2. How the two systems work
  3. A steady row
  4. A 2000 m race
  5. A sprint
  6. Does rowing increase your VO2 max?
  7. Is the rowing machine an aerobic workout?
  8. Why it matters for training
  9. Common confusion

Rowing is both aerobic and anaerobic. Both energy systems contribute all the time, and the balance shifts with how hard and how long you row. A steady hour mostly runs on aerobic metabolism. A 500 m sprint leans heavily on anaerobic sources. A 2000 m race uses a lot of both.

The short answer

For most rowing, the aerobic system supplies most of the energy. Anaerobic work matters most at the start, in hard surges, and in the finish. How much of each depends on duration, intensity and the individual, and published estimates vary.

How the two systems work

The aerobic system uses oxygen to produce energy from carbohydrate and fat. It takes longer to ramp up, but it can keep going for a long time.

The anaerobic system produces energy quickly, from stored phosphocreatine and from the breakdown of carbohydrate when oxygen delivery cannot keep up with demand. It can produce high power for short periods, but it runs down quickly and fatigue builds fast.

“Anaerobic” does not mean “without oxygen.” It describes energy supply when demand is greater than what oxygen delivery can meet at that moment. Both systems are working whenever you row.

A steady row

At easy and moderate effort, the aerobic system supplies nearly all of the energy. A steady UT2 row is mainly aerobic work, which is why it builds the base. Anaerobic contribution is small at this intensity.

A 2000 m race

For most rowers, a 2000 m race takes roughly 6 to 8 minutes. Faster crews finish in around 6 minutes, and recreational rowers often take longer. Published estimates of the aerobic and anaerobic shares vary between studies, but the aerobic system supplies the larger share over the whole piece. The anaerobic contribution is much larger in the first minute or so and in the final sprint. That is why rowers train both.

A sprint

A 500 m sprint, or a race start, lasts well under two minutes at very high intensity. Anaerobic energy supplies a much larger share, and fatigue builds quickly. Sprint work is usually trained with full recovery between efforts, so that each one is done at high quality.

Does rowing increase your VO2 max?

Yes, aerobic training can raise VO2 max, particularly when it includes harder intervals close to maximal intensity. The size of any gain depends on starting fitness, training history and how the training is structured. Gains tend to be larger for people starting from a lower level, and smaller for those already well trained. What a good VO2 max is for a rower explains what the number means and how it is measured.

Is the rowing machine an aerobic workout?

Yes. An erg session can be aerobic at easy and moderate effort, and it can also be a hard anaerobic workout at high intensity. The label depends on effort and duration, not on the machine.

Why it matters for training

Because both systems matter, most rowing plans train both. A large volume of easy aerobic work builds the base, and a smaller amount of threshold, VO2 max and sprint work develops power and speed. The rowing training zones guide maps each zone to the energy system it mainly trains. Heart rate zones for rowing show how to set targets for each one.

Common confusion

  • The “fat-burning zone.” Fat is used at every intensity. The share that comes from fat is higher at lower intensity, but that does not mean one zone burns fat and the others do not. UT2 training in rowing explains why easy work is still the base.
  • “Anaerobic threshold.” The term is used in different ways by different people, and many exercise scientists prefer “lactate threshold,” because it describes what is measured. In rowing, “AT” usually refers to the training zone around that intensity. See anaerobic threshold training for rowers.

The complete guide to training zones

Rowing Training Zones: UT2, UT1 and Beyond
Read the guide

Keep exploring

Guides from other topics

All topics →