Anaerobic threshold (AT) training targets the intensity at which lactate starts to build up faster than the body can clear it. In rowing, the AT zone is a comfortably hard effort. Many rowers find it gives a useful return on their 2k time, provided it sits on top of a solid aerobic base.
What the anaerobic threshold is
During steady exercise at easy intensities, blood lactate stays low. As effort rises, there is a point where lactate starts to accumulate faster than the body can clear it. That point is commonly called the lactate threshold. It is one of the strongest predictors of how long you can sustain a hard effort.
The term “anaerobic threshold” is older, and people use it in different ways. Many exercise scientists prefer “lactate threshold,” because that describes what is measured. In rowing, “AT” usually refers to the training zone around that intensity.
AT pace and heart rate
A common rule of thumb is to row AT about 5 to 10 seconds per 500 m slower than your 2k split. With a 2:00 2k, the AT zone is roughly 2:05 to 2:10 per 500 m. Heart rate is often cited at around 80 to 90 percent of maximum, and stroke rate at around 24 to 28. Heart rate zones for rowing shows how to set your own band.
Feel is the best everyday check. AT is comfortably hard: you can say a few words at a time, but you cannot hold a conversation. If you are gasping or cannot speak at all, you have probably moved into TR.
Why AT matters
For many rowers, AT work is one of the most direct ways to improve a 2k time. Raising the threshold means you can hold a faster pace before fatigue sets in. A 2000 m race keeps much of its effort close to threshold intensity, so this matters for racing as well as for training.
Sample AT sessions
Start each session with 10 to 15 minutes of easy rowing and finish with 5 to 10 minutes of easy rowing. Then choose one of these:
- 2 x 20 minutes, with about 5 minutes of easy rest between them
- 3 x 10 minutes, with about 4 minutes of easy rest
- 4 x 8 minutes, with about 3 minutes of easy rest
- 8 x 1000 m, with about 2 minutes of rest
Start with the shorter or fewer blocks, and add volume only when the pace holds steady across the session.
How often
For most rowers, one or two AT sessions a week is enough, built on a base of mostly easy work. Avoid stacking AT and TR sessions back to back. Many coaches allow at least one easy day between hard sessions, and more if you are fatigued. The 80/20 rule in rowing explains why hard sessions are kept to a small share of the week.
AT vs TR vs AN
- AT is comfortably hard and sustainable for longer intervals.
- TR is harder and used for shorter intervals, to train maximal oxygen uptake. See what VO2 max means for a rower.
- AN is all-out and short, for peak power.
Mixing these is normal, but the names help you choose the right dose. The rowing training zones guide lists each zone’s purpose and rough pace. For the moderate zone just below AT, read UT1 rowing.
Common mistakes
- Going too hard. An AT session pushed toward TR effort loses the threshold benefit and adds fatigue.
- Skipping the base. Threshold work on a thin aerobic base tends to plateau.
- Ignoring recovery. Poor sleep and back-to-back hard days make AT sessions harder to hit correctly.
- Doing only AT. Without easy volume, the hard sessions have less to build on.