Technique

Teaching Rowing: How Coaches Build Good Technique

How coaches teach rowing technique: safety on the water, a sensible teaching order, drills that build the stroke piece by piece, and clear cues.

On this page
  1. What correct technique looks like for beginners
  2. Start with safety and the boat
  3. Choose a teaching order
  4. Build the stroke with drills
  5. Cue one thing at a time
  6. Let beginners settle before you correct
  7. Give feedback learners can use
  8. Common coaching mistakes
  9. Indoor rowers and on-water teaching
  10. Where to go next

What correct technique looks like for beginners

For a beginner, correct technique means a steady, relaxed stroke at a slow rate. At the catch, the arms are straight, the upper body is braced and the shins are close to vertical. The drive runs in order: legs, then body, then arms. The finish is tall and relaxed, and the recovery is controlled, with the arms, body and legs moving back in reverse. Speed and power come later, once that basic cycle is repeatable.

Coaches should aim first for comfort, safety and enjoyment. A learner who gets hurt or overwhelmed early on is less likely to stick with rowing, so the early sessions should be about feeling secure in the boat rather than about output.

Start with safety and the boat

Safety comes before technique. Before the first stroke, cover the boat’s safety features, how to get in and out, and what to do if someone needs help. New rowers often have low spatial awareness, so keep the talk short and check that they have followed it.

Habits that help:

  • Check that no one can get into a position they cannot get out of, such as being wedged against the bank in a windy spot. For a nervous rower, a rope or a hand from the coach can give confidence.
  • Keep every learner in sight, and set up the session so you can see all of them at once.
  • Use some rowing terms, but not too many, and explain the ones you use.
  • Where you can, run the first session in the boat rather than on an indoor rower. Demonstrate a full stroke, and get learners doing full strokes early.

Choose a teaching order

Two orders are common:

  • Finish first. Start at the finish, because the recovery begins there. A clean recovery sets up a clean catch and drive. Teach the finish, then the recovery, then the catch and drive.
  • Catch first. Start at the catch, set the arms and body position, and then teach the drive.

Either works. Whichever you choose, put the pieces together only once each one is steady.

Build the stroke with drills

Drills let learners feel one part of the stroke at a time, and they let you see one fault at a time. Three drills are common:

  • Pick drill. Begin at the finish with arms only. After 10 to 15 strokes, add the body swing from 11 to 1 o’clock. After another 10 to 15 strokes, add the legs for a half slide, then move to the full slide.
  • Legs-only drill. Begin at the catch with arms out and the body over. Drive with the legs only, keeping the body angle constant, so the handle and seat move together.
  • Reverse pick. Begin at the catch with the legs only. After 10 to 15 strokes, add the body swing from 1 to 11 o’clock. After another 10 to 15 strokes, add the arms for a full stroke.

Cue one thing at a time

Keep cues short and tied to one part of the stroke. “Legs, body, arms” covers the drive, and “arms, body, legs” covers the recovery. Give one cue, let the learner repeat it, then add the next.

Analogies help. Some coaches ask learners to think of lifting a box: the legs take the load, the back stays straight, and the arms bring the handle in last. If you use port and starboard, remember that rowers face the stern, so port is on the right. Many coaches teach “port wine is red, and red is right”.

Let beginners settle before you correct

Let learners row slowly and purposefully at first. Watch them for a few strokes before you correct anything. Don’t let them pull hard until the fundamentals feel comfortable, because it is easy to build habits while pushing hard. When the stroke is comfortable, add power and endurance.

Start the session with an easy row, or a drill such as the pick drill, to warm up before the main work.

Give feedback learners can use

  • Ask a learner to compare their positions with a reference picture or a short clip of a correct stroke.
  • Film a short clip from the bank or a launch, then review the catch and finish together. Learners often see a fault on video that they could not feel.
  • Give feedback in short bursts, at the end of a piece or during a rest, unless there is a safety issue.
  • Name what is going well before you name what needs to change.

Common coaching mistakes

  • Talking too much. A learner trying to balance cannot process a long list of corrections.
  • Adding rate or power before the stroke is steady.
  • Losing sight of learners, or letting a nervous rower drift into trouble.
  • Teaching the catch and drive as separate moves instead of one cycle.

Indoor rowers and on-water teaching

The stroke is the same on both, so drills and cues carry over. The setup differs:

  • Foot straps: adjust them so the strap sits over the widest part of the foot, which lets the shins come close to vertical at the catch.
  • Damper: many coaches use a mid-range damper setting, roughly 3 to 5 on a Concept2. A higher damper does not teach better technique.
  • On the water: blade work is part of every catch and finish. Teach it early, but slowly and in calm water.

Where to go next

The complete guide to technique

Rowing Technique: The Stroke Cycle Explained
Read the guide

Keep exploring

Guides from other topics

All topics →