Indoor Rowing

How to Set Up a Rowing Machine: Height, Straps and Monitor

Set up an indoor rower in order: footplate and straps, then height and angle, damper, grip and posture, and a monitor you can read at the finish.

On this page
  1. Set up in this order
  2. Foot straps and footplate
  3. Height: footplate, catch and finish
  4. Damper or resistance
  5. Grip and posture
  6. The stroke order to start with
  7. Monitor placement
  8. Common setup mistakes

Set up in this order

Setting up a rower takes about five minutes if you do the steps in order: straps and footplate first, then height and angle, damper, grip and posture, and finally the monitor. Each step depends on the one before it, so the order matters.

Foot straps and footplate

Place your feet on the footplates and tighten the straps so your feet feel secure. The strap should cross the widest part of your foot, roughly over the ball of the foot or the ends of the laces, not across the arch. Snug is right. Tight enough to cut off circulation is too tight, and loose enough for your heel to slip is too loose.

Keep your heels free enough to lift a little as you slide forward. Many rowers find this natural, and it is part of the stroke, not a fault.

Height: footplate, catch and finish

“Height” on a rower usually means where the footplate sits and how the seat and handle line up with your body. Two checks help:

  • At the catch, the position where you start the drive, your shins should be close to vertical and your arms straight. You should not feel stretched or cramped. If your knees are already fully bent before you reach the catch, the footplate may be too close to the seat.
  • At the finish, when the legs are straight and the handle is pulled in, the handle should sit near the lower ribs or sternum, without you leaning back a long way.

Many rowers can adjust the footplate angle or position. Others have a fixed footplate, and the strap is the main setting. Check the manual for your model.

Damper or resistance

On a Concept2, the damper lever on the side of the flywheel housing is usually set between 3 and 5 for beginners. This is common guidance, not a rule. On other machines, choose a low-to-moderate setting when you start. The drag factor guide explains what the number on the monitor shows, and why a high damper is not a shortcut to a harder workout.

Grip and posture

  • Hold the handle loosely, with your fingers rather than your palms. A tight grip tires your forearms quickly.
  • Sit tall on the front half of the seat, with a neutral spine.
  • Hinge slightly forward from the hips at the catch, with relaxed shoulders.

The stroke order to start with

On the drive: legs first, then the body, then the arms. On the recovery, reverse the order: arms first, then the body, then the knees bend to slide back. Keep the first few sessions at an easy pace while you learn the sequence. The beginner rowing program covers the first weeks.

Monitor placement

Place the rower so you can read the monitor from the catch and the finish without twisting. Many monitors tilt, so adjust the angle while you are seated at the finish, where you are most likely to look at it. Check that the screen is not blocked by the handle or your knees.

Common setup mistakes

  • Straps too loose. The foot moves and the drive loses power.
  • Straps too tight. It restricts blood flow and makes the feet ache.
  • Footplate too close. The knees are bent before the catch, and the stroke feels cramped.
  • Damper too high. It makes the stroke feel heavy without making you faster.
  • Monitor unreadable. You look down to read it and lose your posture.
  • Uneven floor. A rower that rocks or slides is harder to row well. A mat helps.

If anything feels sharp, painful or unstable, stop and check the setup before you row again. Good setup and form help you avoid strain, but they do not replace advice from a doctor or physiotherapist if you have an existing injury.

For how the resistance type affects the setup, see the resistance guide. If noise is a concern in your home, the noise guide covers mats and placement.

The complete guide to indoor rowing

Indoor Rowing Training: How to Build an Erg Program
Read the guide

Keep exploring

Guides from other topics

All topics →