Indoor Rowing

Starting a Rowing Program: A Beginner's First Weeks

A beginner's first weeks on an indoor rower: learn the stroke at an easy pace, add time gradually, try short pieces and keep a simple log of each session.

On this page
  1. Start with the stroke, not the speed
  2. Weeks 1 and 2: easy sessions, short time
  3. Weeks 3 and 4: add time
  4. Weeks 5 and 6: short pieces
  5. How often to row
  6. Form cues beginners forget
  7. Track each session
  8. Common questions

Start with the stroke, not the speed

Your first few weeks on an erg are about learning the stroke. It has four phases: the catch, the drive, the finish and the recovery. On the drive, the legs go first, then the body, then the arms. The recovery reverses that order: arms, then body, then legs. Speed comes later, once the stroke feels automatic.

Set the machine up before your first session. The setup guide covers strap position, damper and seat. Filming yourself from the side, or using a mirror, helps you check the four phases against what you intended.

Weeks 1 and 2: easy sessions, short time

Start with 10 to 15 minutes at an easy pace. Keep the stroke rate low, roughly 18 to 22 strokes a minute, so you have time to think about each phase. Use a low damper setting while you learn. The drag factor guide explains why.

Stop before you are exhausted. Form tends to break down when you get tired: the back rounds, or the arms start doing work the legs should do. If that happens, end the session. Three sessions a week with a rest day between them is a reasonable start.

Weeks 3 and 4: add time

Add a minute or two each week, as long as your form holds for the whole session. A 20-minute session with good form is worth more than a 30-minute session with a rounded back.

Once a week, you can add a short hard piece: 30 seconds at a higher stroke rate, then back to easy rowing. Keep it short and controlled.

Weeks 5 and 6: short pieces

By now you can probably row 20 to 30 minutes at a steady pace. Try short pieces, such as 250 or 500 metres, with rest between them. Time matters more than metres at this stage. Note how long each piece takes, and try to repeat it with the same form.

Pieces are a good way to see progress, but they are not the whole program. The indoor rowing training program shows how steady rows, intervals and tests fit together once the basics are in place.

How often to row

Three sessions a week is a reasonable start. Four is fine once your form holds up and you recover well. Keep at least one full rest day a week. If your legs, back or shoulders stay sore for more than a day or two, reduce the time or the intensity.

Form cues beginners forget

  • Hold the handle loosely. A tight grip wears out your forearms quickly.
  • Push with your legs first. Your legs do most of the work.
  • Keep your shoulders down. Shrugging wastes energy.
  • Keep your elbows close to your body on the drive.
  • Breathe out on the drive and in on the recovery. Holding your breath makes the stroke harder.
  • Lean back only to the finish. Leaning further is not more power, and it often pulls the body out of the stroke.

Track each session

Write down the date, the time, the distance, the damper setting and how the session felt. A simple log shows progress even when single sessions feel the same. The split time guide explains the 500-metre pace on the monitor, which you can record as you improve.

Common questions

What is a good distance for a beginner? There is no single right number. Start with the time you can row with good form, and let distance follow as your fitness improves. For a 30-minute benchmark later on, see what counts as a good distance in 30 minutes.

Is rowing good for bad knees? Rowing is generally low-impact, but knee pain has many causes. If you have knee pain or a past injury, speak to a doctor or physiotherapist before you start.

What mistakes do beginners make most often? Rushing for speed, pulling with the arms first, rounding the back, and rowing hard in every session.

The complete guide to indoor rowing

Indoor Rowing Training: How to Build an Erg Program
Read the guide

Keep exploring

Guides from other topics

All topics →